CNC Cutter Milling Roughing End Mill have scallops on the outside diameter which causes the metal chips to break into smaller segments. This results in lower cutting pressures at a a given radial depth of cut.
Features:
1. The cutting resistance of the tool is greatly reduced, the spindle is less stressed, and ultra-high-speed machining can be realized.
2. The tool manufacturing precision is high, the running of the tool installed on the machine tool is small, the force of each cutting edge is even, the tool vibration is suppressed, and a very high cutting surface finish can be obtained.
3. Since the cutting amount of each cutting edge is uniform, the feed rate can be greatly increased under the premise of ensuring the surface finish unchanged, so that the processing efficiency is greatly improved.
4. The special spiral design improves the chip removal ability of the tool, makes the processing smoother and prolongs the service life of the tool.
5. The service life is dozens of times that of general hard alloy and diamond coating, and the performance is stable.
6. All tools have been tested for dynamic balance, and the tool run out is very small, which ensures the life of the machine tool’s spindle and the safety of use.
Instructions for use
1. Before using this tool, please measure the tool deflection. If the tool deflection accuracy exceeds 0.01mm, please correct it before cutting.
2. The shorter the length of the tool extension from the chuck, the better. If the extension of the tool is longer, please adjust the speed, in/out speed or cutting amount by yourself.
3. If abnormal vibration or sound occurs during cutting, please reduce the spindle speed and cutting amount until the situation improves.
4. The preferred method of cooling steel material is spray or air jet, so as to use cutters to achieve better results. It is recommended to use water-insoluble cutting fluid for stainless steel, titanium alloy or heat-resistant alloy.
5. The cutting method is affected by the workpiece, machine, and software. The above data is for reference only. After the cutting state is stable, the feed rate will be increased by 30%-50%.
If you are interested in our products, please visit our website
https://www.mskcnctools.com/4mm-34-flute-straight-shank-cnc-cutter-milling-roughing-end-mill-product/
Post time: Dec-17-2021
