China New Product 30 Degree Chamfer End Mill - HRC 65 tungsten steel two-edged ball end milling cutter R milling cutter alloy end milling cutter – MSK

The new fine-grained tungsten steel material has high abrasion resistance and strength. nACo coating on the edge of the milling cutter dedicated to high-hardness and high-speed cutting applications can directly perform high-speed rough machining to fine machining on the following heat-treated materials of HRC60.

Advantage:

1. Rugged use, using new fine-grained tungsten steel with high wear resistance and strength, an all-round milling cutter dedicated to high-hardness high-speed cutting applications
2. The cutting edge is covered with nACo coating, which can directly perform high-speed roughing to finishing for heat-treated materials below 60 degrees, reducing the number of tool changes and advance the machine tool utilization rate, saving production time, with cutting face milling/short side milling Mainly
3. The 2-flute is mainly used for cutting grooves, and the 4-flute is mainly used for measuring and face milling. It is recommended to cut steel under HRC60
4. Chamfering, easy to use, exclusive milling cutter for high-hardness high-speed cutting applications. Use high-speed knives on high-speed machines

Instructions for use

In order to get a better cutting surface and prolong tool life. Be sure to use high-precision, high-rigidity, and relatively balanced tool holders.
1. Before using this tool, please measure the tool deflection. When the tool deflection accuracy exceeds 0.01mm, please correct it before cutting
2. The shorter the length of the tool protruding from the chuck, the better. If the tool protruding is longer, please reduce the combat speed, feed speed or cutting amount by yourself
3. If abnormal vibration or noise occurs during cutting, please reduce the spindle speed and cutting amount until the situation is changed.
4. The steel material is cooled by spray or air jet as the applicable method to make the high aluminum titanium exert a good effect. It is recommended to use water-insoluble cutting fluid for stainless steel, titanium alloy or heat-resistant alloy.
5. The cutting method is affected by the workpiece, machine, and software. The above data is for reference. After the cutting condition is stable, increase the feed rate by 30%-50%.

Use:

Aviation Manufacturing

Machine Production

Car manufacturer

Mold making

Electrical Manufacturing

Lathe processing